Wild Dog Adventure Riding

Technical Section => Make / Model Specific Discussions => KTM LC4 400/610/640 & 690 => Topic started by: Jules on January 22, 2013, 01:05:11 pm

Title: 690 Handel Bar map switch
Post by: Jules on January 22, 2013, 01:05:11 pm

Is it worth doing or do most of you simply stick to one map for all your ridding?
Does the novelty of switching maps wear off ;-)

Best place to buy the switch?

Thanks


Jules

Title: Re: 690 Handel Bar map switch
Post by: KTM11 on January 22, 2013, 02:52:03 pm

I simply stick to the 1 map setting for all my riding, I have tried all 3 settings and now just run the bike on the standard map setting.

Title: Re: 690 Handel Bar map switch
Post by: 777 on January 22, 2013, 04:46:47 pm

Only map 2 and 3 work so waste of time

Title: Re: 690 Handel Bar map switch
Post by: Jules on January 22, 2013, 05:21:45 pm

Quote from: 777 on January 22, 2013, 04:46:47 pm

Only map 2 and 3 work so waste of time

You ride on 2 or 3?

Title: Re: 690 Handel Bar map switch
Post by: GJ on January 23, 2013, 12:25:24 am

On 3

Title: Re: 690 Handel Bar map switch
Post by: KTM11 on January 23, 2013, 08:40:40 am

I run mine on 3 ...had it on 2 for a while but 3 just feels smoother....

I tried mine on 1 and it felt like I was riding a BMW  :pot: no power at all

Title: Re: 690 Handel Bar map switch
Post by: Hooli on January 28, 2013, 10:09:23 pm

Hi

I have a toertech switch and to be quit honest I played around with it in the beginning, but now only use it on 3. I wheely alot and on 3 it is much better to control than the wild setting. Tried the 1 setting going up steep rocky mountain past (4x4 route) and didnt work at aal, changed back to 3 and everything was fine.