Wild Dog Adventure Riding

Technical Section => Make / Model Specific Discussions => Honda CR / CRF / Africa Twin 1000 => Topic started by: DavidMorrisXp on October 01, 2017, 09:22:37 am

Title: AT sprockets
Post by: DavidMorrisXp on October 01, 2017, 09:22:37 am
Has anybody changed the gearing on their AT, I am thinking of going either one smaller on the CS or two to three bigger on the rear?

I donít know where the speedo reads the speed from and if it is the CS, I would rather modify the rear as that speedo already lies like a cheap watch showing more than 10% over
Title: Re: AT sprockets
Post by: Bwana on October 02, 2017, 12:53:22 pm
I know Edgy and Losper have gone one tooth less on drive sprocket to shorten 1 st gear a bit they say it is much better.
Title: Re: AT sprockets
Post by: edgy on October 02, 2017, 01:11:31 pm
I went 1 tooth smaller up front and I prefer it, Losper says he went back to stock?
I dont know or really worry what the speedo says :lol8:
Title: Re: AT sprockets
Post by: DavidMorrisXp on October 02, 2017, 01:16:59 pm
I went 1 tooth smaller up front and I prefer it, Losper says he went back to stock?
I dont know or really worry what the speedo says :lol8:

Cheers
Title: Re: AT sprockets
Post by: Losper on October 02, 2017, 01:27:32 pm
Yeah I went back to original sprocket but I am keeping the smaller sprocket for those serious technical days' :thumleft:
Title: Re: AT sprockets
Post by: DavidMorrisXp on October 02, 2017, 01:31:32 pm
Found one PBR 15 tooth for about R 345.60

Any other recommendations?
Title: Re: AT sprockets
Post by: Old Man on December 03, 2017, 04:52:52 am
We are doing a long non technical ride early in the new year. I am looking to go 1 tooth bigger on the rear to see what it does to the fuel consumption. Does anyone know where I can source such a sprocket? I only seem to be able to find a standard rear.
Title: Re: AT sprockets
Post by: DavidMorrisXp on December 03, 2017, 06:15:59 am
We are doing a long non technical ride early in the new year. I am looking to go 1 tooth bigger on the rear to see what it does to the fuel consumption. Does anyone know where I can source such a sprocket? I only seem to be able to find a standard rear.

I found my sprocket on the pbr website http://pbr.it/ then I was able to get it from the Trac Mac store once I knew the part number