Welcome, Guest. Please Login or Register

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - superfoxi

Pages: [1]
1
General Bike Related Banter / Re: QR 50 Workshop manual
« on: June 10, 2018, 11:09:29 pm »
I can have the owners manual and workshop manual in PDF format.
Just send me a message...
The following users thanked this post: chris g

2
I have lots of pullers but not sure if any of them will work in this case. You are welcome to bring the motor and we can check.
I'm in Capri Village /Southern Peninsula. Send me a message or give me a call if you like.0788448830
Mike
The following users thanked this post: Mr D

3
I have some templates in different formats. Just send me a pm with your email address.
The following users thanked this post: LegoBrew

4
Suzuki DR & DRZ / Re: DR650 fork/shock covers
« on: May 10, 2018, 10:53:48 am »
I can only get them for you next week. Or she can go to Craig's Motorcycles in Maitland. They are very helpful and might have stock of aftermarket fork boots. Don't buy the ones from Startline. They don't last...
The following users thanked this post: Jack Stone

5
General Technical / Re: Leaking Fork Seals
« on: March 05, 2018, 10:52:48 am »
Armpump, thanks for the advice, I appreciate it  :thumleft:
At the bottom of the shocks there are what appears to be bleed screws that you can open and close with a allen key, not sure if it is the same as the release on the top of other bike forks.

Your bike doesm't have bleed screws. That screw at the bottom is keeping your forks together. Don't open it...
The following users thanked this post: Edgar

6
Kawasaki KLR 600/650 / Re: Engine cuts out at ful throttle
« on: March 05, 2018, 09:19:58 am »
Could be a (partly) blocked main jet - or even water in the float bowl.
Close the petrol tap and drain the carb (drain screw is at the bottom of the float bowl).
Also have a look if the air filter is maybe dirty.
If that doesn't help - bring it to a mechanic.
The following users thanked this post: The Pale Male

7
I can get you one for around R800. Just send me a message if you are interested.
The following users thanked this post: Clooney

8
Thank you very much for your support and taking the time to document the installation.
Much appreciated!  :thumleft:
The following users thanked this post: Horizon Seeker

Pages: [1]