Welcome, Guest. Please Login or Register

Author Topic: DRZ 400 Clutch shaft seal  (Read 459 times)

0 Members and 1 Guest are viewing this topic.

Offline Frannarossi

  • Vendor
  • Senior Member
  • ***
  • Bike: BMW R1200GS Adventure
    Location: Western Cape
  • Posts: 3,606
  • karoorooster@gmail.com
DRZ 400 Clutch shaft seal
« on: April 14, 2014, 04:00:47 pm »
Where can I buy one of these seals?
« Last Edit: April 14, 2014, 04:01:55 pm by Frannarossi »
If you don't live on the edge,you take up too much space!!!
 

Offline Dux

Re: DRZ 400 Clutch shaft seal
« Reply #1 on: April 14, 2014, 09:13:28 pm »
Seal size 10 x 20 x 7 , available at any Bearing Man
Motoworx
motoworx1@gmail.com
073 232 5389
Unit 6 Viben square
8 Viben Road , Brackenfell
 

Offline Frannarossi

  • Vendor
  • Senior Member
  • ***
  • Bike: BMW R1200GS Adventure
    Location: Western Cape
  • Posts: 3,606
  • karoorooster@gmail.com
Re: DRZ 400 Clutch shaft seal
« Reply #2 on: April 15, 2014, 07:28:50 am »
Thanks a lot! :thumleft:
If you don't live on the edge,you take up too much space!!!
 

Offline Frannarossi

  • Vendor
  • Senior Member
  • ***
  • Bike: BMW R1200GS Adventure
    Location: Western Cape
  • Posts: 3,606
  • karoorooster@gmail.com
Re: DRZ 400 Clutch shaft seal
« Reply #3 on: April 28, 2014, 03:45:43 pm »
The 20x10x7 size isn't the right one.I bought two,fitted the first one and it lasted for 150 kms and started leaking again.I sanded the second one down to a 6 and fitted it yesterday.Will see what it does.....The original size is actually a 20x10x6.
If you don't live on the edge,you take up too much space!!!
 

Offline Dux

Re: DRZ 400 Clutch shaft seal
« Reply #4 on: April 28, 2014, 03:49:35 pm »
The 10x20x7 is what is recommended in the Suzuki microfiche , is there any wear on the shaft or any sharp lips that can cut the seal a bit further down the shaft .
Motoworx
motoworx1@gmail.com
073 232 5389
Unit 6 Viben square
8 Viben Road , Brackenfell
 

Offline Frannarossi

  • Vendor
  • Senior Member
  • ***
  • Bike: BMW R1200GS Adventure
    Location: Western Cape
  • Posts: 3,606
  • karoorooster@gmail.com
Re: DRZ 400 Clutch shaft seal
« Reply #5 on: April 28, 2014, 04:35:55 pm »
Nothing,but the original seal seals on the bottom and the seal I bought from bearing man seals on the top....The 7 makes it stand out about 1 mm,so if it gives me shit again,I'll try the original seal from Suzuki.
If you don't live on the edge,you take up too much space!!!