Sproket
Puppy
Good Day!
1st)Can anyone please tell me which two of the four wires must I use, to bypass the exhaust mapping sensors with 13.9ohm resistors?
2nd)Is 13.9ohm resistors adequate?
3rd)Will it make a major improvement on the performance as predicted, Or is it a total waste of time?
1st)Can anyone please tell me which two of the four wires must I use, to bypass the exhaust mapping sensors with 13.9ohm resistors?
2nd)Is 13.9ohm resistors adequate?
3rd)Will it make a major improvement on the performance as predicted, Or is it a total waste of time?
