grego
Race Dog
I've recently been doing a bit of work on my brothers 2006 DRZ400E.
While reassembling the carb (Keihin FCR), i noticed an error in the parts diagram for the carb.
Both my Clymer manual and the online parts fiches have the same erroneous diagram.
Part No. 8, the vacuum release plate, is shown in the wrong orientation.
It should be rotated through 180 degrees, as per my pencil correction.
I'm pretty sure the bike would not be happy if this plate was fitted as per the manual.
While reassembling the carb (Keihin FCR), i noticed an error in the parts diagram for the carb.
Both my Clymer manual and the online parts fiches have the same erroneous diagram.
![](https://proxy.imagearchive.com/641/6410e66b26a90aef33155c96298ead3a.jpg)
Part No. 8, the vacuum release plate, is shown in the wrong orientation.
It should be rotated through 180 degrees, as per my pencil correction.
I'm pretty sure the bike would not be happy if this plate was fitted as per the manual.