Bliknêrs
Race Dog
Hi guys
I had to remove my tank to get my side panels off for some plastic repair work as my crash bars don't allow for the panel removal with the tank on.
My bike needs a Throttle body sync and I need to check the rubber boots are still seated, so I decided to remove the tank and airbox and do it all at once.
One I'm in there, I would also like to extend the vacuum pipes for easier syncing in the future.
But the main reason was a persistent fuel leak and from the internet it seems like a piece of high pressure pipe needs to be replaced. I needed to fix this before my bike goes up in flames!
So I decided to do it all at once, and take photos to put up here if anyone else would like to do the same, give me pointers etc
I had to remove my tank to get my side panels off for some plastic repair work as my crash bars don't allow for the panel removal with the tank on.
My bike needs a Throttle body sync and I need to check the rubber boots are still seated, so I decided to remove the tank and airbox and do it all at once.
One I'm in there, I would also like to extend the vacuum pipes for easier syncing in the future.
But the main reason was a persistent fuel leak and from the internet it seems like a piece of high pressure pipe needs to be replaced. I needed to fix this before my bike goes up in flames!
So I decided to do it all at once, and take photos to put up here if anyone else would like to do the same, give me pointers etc
