0 Members and 1 Guest are viewing this topic.
I collected the cush drive washers and rivets for the clutch yesterday and heat treated them today, so we are ready to rock.I think I am going to start a new topic.
The problem I am sitting with is what colour should I make the frame, swing arm and hubs to tie into the gold rims at the bottom and the red and white plastics on the top?Seems that gold rims might be a bit limiting and that I should have gone black or silver for a red and white top? What you guys think?A few photo's I have found on the net
Busy surfing the Net to look for alternatives to the OEM timing chain -Seems there are 3 possibilities from DID - DID SCA0412A SDH DID SCA0412SV-122 DID SCR0412SV-122 The SV is apparently stronger (and more expensive) due to the fact that it uses "new bolts, which through the use of special coatings are characterized by higher resistance to abrasion compared to SCA0404A SDH; SCA0409A SDH, SDH SCA0412A"Anyone else went down this road before and can give some advice or insight?
Quote from: Matie spero on December 09, 2015, 02:19:52 pmwaars die fotos van jou jewish racing gold colour rims?Lekker tappit!vra ek mos kykdaar noudie dag waste kleur is sy tappit cover en of hy hom gaan verf, toe se hy my nee, dis n suursteen huis, hy gaan hom nie verf nie!
waars die fotos van jou jewish racing gold colour rims?Lekker tappit!vra ek mos kykdaar noudie dag waste kleur is sy tappit cover en of hy hom gaan verf, toe se hy my nee, dis n suursteen huis, hy gaan hom nie verf nie!