Altie7deLaan
Race Dog
- Joined
- Nov 5, 2011
- Messages
- 1,966
- Reaction score
- 137
- Location
- durbanville
- Bike
- Husqvarna (all models)
hi
I have a 2009 690 enduro with an intermittent cut out, happened about 4 times in the last 1500 km.
Bike`s motor cut out completely, although dash is still live.
The times this have happened, I coasted it to a stop with the clutch in.
When the bikes comes to a stop, just hit the starter and it fires to life and gets going again.
I am thinking of bypassing the sidestand switch, anybody done this?
I found a snippet on the internet about a guy with a 09 690 motard, and according to him there is a pink and black wire that needs to be linked via a 2000ohm resistor.
Any advice/thoughts please.
I have a 2009 690 enduro with an intermittent cut out, happened about 4 times in the last 1500 km.
Bike`s motor cut out completely, although dash is still live.
The times this have happened, I coasted it to a stop with the clutch in.
When the bikes comes to a stop, just hit the starter and it fires to life and gets going again.
I am thinking of bypassing the sidestand switch, anybody done this?
I found a snippet on the internet about a guy with a 09 690 motard, and according to him there is a pink and black wire that needs to be linked via a 2000ohm resistor.
Any advice/thoughts please.
