Hi Ladies and Gents. I have noticed since the bike was new, that after the coolant level has been topped up to the half way mark, it only takes about 100km of riding until it is back to the lower level mark on the coolant bottle.
Then this is where it stays until topped up again.It takes 200ml to fill half way again. I have checked for leaks, tightened the hose clamps and checked the cap is seated properly.Engine oil does not show it is contaminated with water either. Anyone else with this problem?
Is the coolant bottle cap supposed to have a seal in it?
Thanks
Mark
Then this is where it stays until topped up again.It takes 200ml to fill half way again. I have checked for leaks, tightened the hose clamps and checked the cap is seated properly.Engine oil does not show it is contaminated with water either. Anyone else with this problem?
Is the coolant bottle cap supposed to have a seal in it?
Thanks
Mark
