WANTED: machine shop that can do HDPE/Nylon, etc

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

zebra

Bachelor Dog
Joined
Jun 23, 2008
Messages
14,299
Reaction score
912
Location
8 Shropshire Street, Paarden Eiland, Cape Town
Bike
BMW (all models)
WANTED: machine shop that can machine HDPE/Nylon, etc...


Runner (Offroad Cycles) and I share the selling of this 5L fuel cell (or 5L water cell) mount, which consists of:


UPPER HDPE part, which screws down into 5L fuel cell recess. (threaded)
LOWER HDPE part, which forms the base that the 5L fuel cell rests upon. (threaded)
STAINLESS STEEL m-a-i-n bolt dimensions: 16mm x 120mm
STAINLESSS STEEL NYLOCK dimensions: 16mm nut
MILD STEEL base plate dimensions 88mm x 5mm
2 x stainless steel cap-head bolts dimensions: 8mm x 20mm
1 x 'R' clip, 7cm long.


We need a 'machine shop' who can fabricate:
either the WHOLE unit...
OR
j-u-s-t the HDPE/Nylon parts (upper and lower) and WE will source the rest of the products, and do assembly.


thanks!
Chris & Team
021 510 6455
www.flyingbrick.co.za
[email protected]
 

Attachments

  • 2018-03-23 10.20.38.jpg
    2018-03-23 10.20.38.jpg
    491.2 KB · Views: 250
  • 2018-03-23 10.20.19.jpg
    2018-03-23 10.20.19.jpg
    492.3 KB · Views: 254
  • 2018-03-23 10.20.03.jpg
    2018-03-23 10.20.03.jpg
    491.6 KB · Views: 249
  • 2018-03-23 10.21.25.jpg
    2018-03-23 10.21.25.jpg
    491.8 KB · Views: 252
Top