Welcome, Guest. Please Login or Register

Author Topic: Wiring diagram Extreme Lights LED  (Read 127 times)

0 Members and 1 Guest are viewing this topic.

Offline Stormer69

  • Newbie
  • *
  • Bike: BMW R1200GS
    Location: Mpumalanga
  • Posts: 17
Wiring diagram Extreme Lights LED
« on: January 28, 2019, 09:52:50 am »
Morning all and sundry,

Purchased a set of extreme LED lights for my 1200 GS (2008). I received the full wiring harness with the lights but I am unsure how to wire it in so that it forms part of the ignition. Meaning the lights must be powered only once the ignition is turned on.

The kit includes the switch as well as the relay and in line fuse.

Any suggestions..
 

Offline Black_Hawk

  • BackroadRiderZA
  • Senior Member
  • ***
  • Bike: BMW F800GS
    Location: Western Cape
  • Posts: 3,158
  • Thanked: 192 times
  • Follow our blog: https://mytownsatoz.wordpress.com
    • My Towns A to Z
Re: Wiring diagram Extreme Lights LED
« Reply #1 on: January 28, 2019, 11:03:20 am »
Hi Stormer69, I hope that attached will be of help.

Please note that there is a How to Wire a Relay for Off-Road LED Lights.doc that you can download with more details.
« Last Edit: January 28, 2019, 11:05:04 am by Black_Hawk »
Follow our blog: https://mytownsatoz.wordpress.com

2010 F650GS (Sold), 2009 BMW F800GS, 2002 BMW F650GS (Sold), 1982 Honda XR 200R, 1982 Honda XL 600R
 
The following users thanked this post: Stormer69

Offline Jughead

  • Old rail tunnel, Cradock.
  • Forum Whore
  • ****
  • Bike: BMW R1200GS Adventure
    Location: Eastern Cape
  • Posts: 5,344
  • Thanked: 171 times
  • Port Elizabeth
Re: Wiring diagram Extreme Lights LED
« Reply #2 on: January 28, 2019, 11:12:51 am »
As per Black Hawk's diagram if you really want to use the harness and relay.  Yellow wire to the headlight is the dim(which means the spots will always be available), White wire is the bright (which means the spots will only come on when the bright light is on).

If you are using the 10W LED spots, you can actually dispense with the entire harness except the switch.  Two red wires from the spots go directly to the white or yellow wire to the headlight (depending as above how you want the lights to operate), the two black wires are connected to the one wire to the switch and the other wire from the switch goes down to ground.

No fuse is necessary as the fusing is then done via the bike'e electronic fuses.
« Last Edit: January 28, 2019, 11:14:17 am by Jughead »
I came here to drink milk and kick arse!  And i've just finished my milk.
http://www.dsmc.co.za        http://www.triumphowners.com/to-car/mkiii/
Supplier of Ticket to the Moon Hammocks   http://www.ticketothemoon.com             
 
The following users thanked this post: Stormer69