Recent content by gmostert

Baie Dankie ek sal hulle n luitjie gee! Sent from my iPhone using Tapatalk

Hi Looking for recommendations: Would like to add some nice graphics , any recommendations in Cape Town Area ?? Sent from my iPhone using Tapatalk

My Motor dropped quite Easley , but yes that 12oClock starter cable mount required a second set of hands or a strap as you say! Sent from my iPhone using Tapatalk

Yip , easy enough install just allot of strip work! Sent from my iPhone using Tapatalk

https://advrider.com/f/threads/1190-starter-removal-instructions.1042420/ Might be in this thread already , but very useful info in link to ADV rider..[emoji482] Sent from my iPhone using Tapatalk

Yip , and installed Rottweiler fuel dongles ! Sent from my iPhone using Tapatalk

To support the engine as you remove the right hand side engine mount completely and loosen the left side one , as well as loosen the swing arm bolt ( goes through the rear of the engine ) .As the engine needs to tilt forward about 10mm to get the starter out and the new one in . Past the Frame ...

Thanks , she hasn’t seen much  dirt lately unfortunately... So much Sh8t in the way , just took my time and a little gentle persuasion, and all worked out in the end . Splines didn’t line up so I put it in gear to nudge the engine a bit to get the splines to line up , once all was in place and...

Thanks , that was very informative! Sent from my iPhone using Tapatalk

Did my starter upgrade today , bike now starts like it should! Throttle bodies are easy enough to remove vs battling with the harness bolt.. 5 hours with the odd coffee break , not to hard to do just time consuming. Sent from my iPad using Tapatalk

Hi Has anybody removed the Catalytic converter , mine broke inside the pipe and the rattling caused a sizable hole in the pipe. Pipe is off and being repaired , now what I would like to know is if the bike will require an ECU flash or Power commander to ensure it’s not running too lean ? I see...

So while doing the 30k service , I noticed some moisture on the bottom of the radiator , which needs to be loosened to remove front tappet cover . I stripped bike myself , did the service , changed chain and sprockets etc. the shims I measured and found intakes tight , decided cam removal was...

. Sent from my iPhone using Tapatalk

Nice ! Sent from my iPhone using Tapatalk

I find this quite sad really , I make a comment about a fellow " Biker " that is endangering not only his life but mine aswell , by almost taking me out ( three times already by blasting past me while I am lane splitting ) and I am certain giving car drivers a fright of note !! Yet my first two...