Welcome, Guest. Please Login or Register

Author Topic: Project:21 inch GS adventure front - tested on the mud monster  (Read 6039 times)

0 Members and 1 Guest are viewing this topic.

Offline aka.Goliath

Re: Project:21 inch GS adventure front - tested on the mud monster
« Reply #100 on: April 05, 2013, 01:39:37 am »
Anyone have any ingenious ideas on how to make a bracket to move ones mud guard above the clamp? I have designed a simply clamp but don't know if it will work.

It fits on from the back and attaches to the bike using the bottom holes and original screws. The mud guard would be cut in half between the screw holes and cut away at to make space for the wish bone and break lines. Both the rear and 2 front supports would be have to be bent just a little and attached using 3M double-sided tape, and then screwed down in the original hole in the plastic. It would likely have to be laser-cut and the bottom arm support would have to be welded or bent not quite sure which is stronger. Anyone know who can help making this?

BMW 1150 GSA - 2004
KTM 690R - 2014
KTM 300 X-CW - 2012
KTM 530 EXC Rally - 2011 SOLD, KTM 690R - 2009 SOLD, BMW 1200GS 2009 SOLD
 

Offline T Rex

  • Senior Member
  • ***
  • Bike: BMW R1200GS Adventure
    Location: Gauteng
  • Posts: 1,894
Re: Project:21 inch GS adventure front - tested on the mud monster
« Reply #101 on: April 07, 2013, 02:55:30 am »
Subscribe