- Joined
- May 14, 2007
- Messages
- 2,060
- Reaction score
- 235
- Location
- Roodepoort
- Bike
- Husqvarna (all models)
What should I use to seal the joint where the exhaust header and aftermarket exhaust meets? Mine leaks a little but luckily I've lined the airbox with heat shield so it has not burnt through. I'm getting a new gasket as the existing one is a bit buggered but in the past when the gasket was still good I tried about 3 different high heat sealants recommended by various bike / hardware shops but nothing worked. After a few hundred kms the stuff gets blown out and the joint leaks.
