KAMAKAZI PILOT
Pack Dog
Hi all
Was wondering if anyone could perhaps help me.
I'm in the process of rebuilding my XR's motor. So far I have found that it has 1.0mm overbore with a Wiseco 11:1 piston. which is all good and well but that means next overbore is 628. :ricky: hope its reliable.
Now for my question to you, does anyone perhaps know what the standard Conrod markings are?
On the one in here it says MNI or MN 1 towards the big end and 10 or I0 towards the top end. these markings are on the lefthand side only.
Is this the standard rod or an aftermarket job?
???
Thanks
Kyle
Was wondering if anyone could perhaps help me.
I'm in the process of rebuilding my XR's motor. So far I have found that it has 1.0mm overbore with a Wiseco 11:1 piston. which is all good and well but that means next overbore is 628. :ricky: hope its reliable.
Now for my question to you, does anyone perhaps know what the standard Conrod markings are?
On the one in here it says MNI or MN 1 towards the big end and 10 or I0 towards the top end. these markings are on the lefthand side only.
Is this the standard rod or an aftermarket job?
???
Thanks
Kyle