GKellerman
Pack Dog
Hi guys,
Looking for someone to give me a bit of advice on the following problem.
We went for a nice 250km ride on Saturday which was more than probably 80% gravel. My bike was a bit dirty and dusty when I got back and I did a bit of a rinse the next day where I just sprayed of the bike, as usual...........not wanting to deep clean as I will be doing a bit of gravel travel again during the holiday.
Switching the bike on today, the display backlight came on, but no display.
I have checked and tested the fuses but nothing seems to be wrong in that department. I will trace the wires tomorrow as one of the wires could probably haves scuffed and not make contact. I have also loosened the unit to check for any water or moist inside but there is no liquid or dampness inside........just lots of dust.......
Any ideas what could be wrong or anyone who had a similair problem before?
The pics attached is the ignition in the on position, bike in neutral and kill switch in start position where it usually gives you the gear readout, fuel level and oil temperature.
Any comments appreciated.
Thanx
Looking for someone to give me a bit of advice on the following problem.
We went for a nice 250km ride on Saturday which was more than probably 80% gravel. My bike was a bit dirty and dusty when I got back and I did a bit of a rinse the next day where I just sprayed of the bike, as usual...........not wanting to deep clean as I will be doing a bit of gravel travel again during the holiday.
Switching the bike on today, the display backlight came on, but no display.
I have checked and tested the fuses but nothing seems to be wrong in that department. I will trace the wires tomorrow as one of the wires could probably haves scuffed and not make contact. I have also loosened the unit to check for any water or moist inside but there is no liquid or dampness inside........just lots of dust.......
Any ideas what could be wrong or anyone who had a similair problem before?
The pics attached is the ignition in the on position, bike in neutral and kill switch in start position where it usually gives you the gear readout, fuel level and oil temperature.
Any comments appreciated.
Thanx
